Page 1 of 2
Windows NT4 FAT32 Driver
Posted:
29 Nov 2007, 09:04by awergh
I found the sysinternals fat32 driver i wondered about and lots of sysinternals stuff appears to be there, as in all the stuff that would have been taken down by sysinternals or microsoft
FAT32 is a FAT32 file system driver for Windows NT 4.0. Once installed, any FAT32 drives present on your system will be fully accessible as native Windows NT volumes.
According to
BearWindowsIf FAT32.SYS driver set to boot mode start it is possible to BOOT from FAT32 partition in NT4.
Fat32.zip
Re: Windows NT4 FAT32 Driver
Posted:
30 Nov 2007, 16:33by marxo
This really looks great, have you tested it?
Re: Windows NT4 FAT32 Driver
Posted:
30 Nov 2007, 23:58by awergh
not yet but i should do it sometime
Re: Windows NT4 FAT32 Driver
Posted:
02 Dec 2007, 12:27by marxo
So basically after installing this driver we could boot from a FAT32 partition?
Re: Windows NT4 FAT32 Driver
Posted:
03 Dec 2007, 01:18by awergh
i think so, this would go well with the udma driver i think
Re: Windows NT4 FAT32 Driver
Posted:
25 Dec 2007, 13:03by nateklomp
Hiya,
Is this the READONLY ("free") version, or the READ-WRITE ("pro") version?
Thanks!
Re: Windows NT4 FAT32 Driver
Posted:
25 Dec 2007, 13:07by marxo
I believe that this is Free and Read-Write version.
Because awergh mentioned you can boot and install on that partition.
Re: Windows NT4 FAT32 Driver
Posted:
03 Jan 2008, 03:08by awergh
i just tested this driver and i can read write to fat32
Re: Windows NT4 FAT32 Driver
Posted:
03 Jan 2008, 16:01by marxo
A great addition to NT4...
Re: Windows NT4 FAT32 Driver
Posted:
09 Jan 2008, 17:47by Mortagen
can this be combined with the udma driver for large drive support and be integrated with nLite into NT4 itself? this would be good for when you setup and install NT4 rather than having to worry about it post-installation.
Just an idea!
Regards, Mortagen
